Key:addr:flats

From OpenStreetMap Wiki
Jump to navigation Jump to search
Public-images-osm logo.svg addr:flats
Entrance code and flat range.jpg
Description
The range of unit numbers within a larger building or complex. For example the range of flats behind the entrance door of a building. Show/edit corresponding data item.
Rendering in OSM Carto
Rendering of addr flats 2.png
Group: addresses
Used on these elements
may be used on nodesshould not be used on waysmay be used on areas (and multipolygon relations)should not be used on relations (except multipolygon relations)
Useful combination
See also
Status: de facto

Use addr:flats=* for marking the range of numbers of flats in a building or behind a door, for example, addr:flats=97-117. If there is gap in numeration, mark numbers and intervals with semicolon: addr:flats=3-7;10;14;16-18.

Is some regions, if there is only one flat, the tag addr:unit=* is normally used instead.

A leading semicolon can be used when a flat number is implicit. For example a house at '10 Some Street' converted into 3 flats with postal addresses of '10 Some Street', 'Flat 1, 10 Some Street' and 'Flat 2, 10 Some Street' can be tagged addr:flats=;1-2 and addr:housenumber=10.

How to map

Where there are multiple entrances to the building and each entrance leads to a different set of flats, then tag the respective addr:flats=* on each entrance.

Where the building only has one entrance or there are multiple entrances but each entrance is not marked for a specific set of flats, then you can either tag addr:flats=* on the main entrance=* node, or on the building=* way.

You should only place addr:flats=* on multiple entrance=* nodes where the value of addr:flats=* is not the same on each entrance=*.

Rendering

Example of addr:flats rendered on osm.org:

Rendering of addr flats.png

Similar tags

addr:flat=* - is used 103 times as of 2022-06-06, and is not documented.

This seems to be mostly used on businesses, and could perhaps be replaced with addr:flats=* or addr:unit=*.

See also

  • building:flats=* - to specify the total quantity of flats (apartments/units) in a building.
  • addr:unit=* - for the address of a single unit, including flats, offices etc.
  • ref=* - for reference code of entrance (present in some buildings where there are multiple staircases - staircase coded as 1, 2, 3... or A, B, C... or I, II, III... are common)